Ballpark Lab

Driveway Cost Calculator / Alabama

Alabama driveway estimate

Driveway Cost in Alabama (2026)

Paving a driveway in Alabama runs roughly 11% below the national average on installed labor, which we apply to the per-square-foot rate for every material. Last updated July 6, 2026.

A typical two-car concrete driveway in Alabama

600 sq ft (20 × 30 ft), 4 in broom-finish slab, flat lot, new build — a clean baseline before you customize.

$3k – $8k
Input completenesshigh

Based on the model's answered input checks, including defaults. This is not verified price accuracy or a statistical confidence level.

Material takeoff

Concrete (with waste)
8 yd³
Form boards
100 lf
Gravel base course
10 tons

Cost breakdown

concrete surface (installed)
$4k – $9k
Permit allowance
$50 – $250
Total
$3k – $8k
Model estimate
$5,474
  • Rate assumes a 4 in concrete section on a standard base; your 4 in depth scales the material share.
  • Contractors typically cut control joints every 8–12 ft on concrete, depending on slab shape and local practice.
  • A new curb cut or apron in the public right-of-way needs Alabama/municipal approval, and flatwork permits and HOA paving rules vary by town.

Where these numbers come from: installed-price surveys + regional references, updated July 6, 2026 — see our methodology.

What drives driveway cost in Alabama

Alabama drives are concrete country: no meaningful frost line, no salt season, and labor about 11 percent below the national average make broom-finish concrete cheap to place and long-lived. The engineering variable is red clay, which drains slowly and pumps when wet — a compacted stone base keeps slabs from rocking. Summer thunderstorms reward crowned surfaces and honest drainage paths. Rural properties keep gravel completely respectable, and permitting is light outside the cities.

Estimate your driveway in Alabama

Driveway details

Street to garage, in feet.

A two-car drive is ~20 ft.

Thicker sections cost more but carry more load.

Anything but a new build adds removal and disposal.

Estimated total
$3,249–$8,233
Concrete · 4 in
Low $3kMost likely ~$5,474High $8k

$3k – $8k · $9 per square foot (/sq ft)

Input completenesshigh

Based on the model's answered input checks, including defaults. This is not verified price accuracy or a statistical confidence level.

Material takeoff

Concrete (with waste)
8 yd³
Form boards
100 lf
Gravel base course
10 tons

Cost breakdown

concrete surface (installed)
$4k – $9k
Permit allowance
$50 – $250
Total
$3k – $8k
Model estimate
$5,474
  • Rate assumes a 4 in concrete section on a standard base; your 4 in depth scales the material share.
  • Contractors typically cut control joints every 8–12 ft on concrete, depending on slab shape and local practice.
  • A new curb cut or apron in the public right-of-way needs Alabama/municipal approval, and flatwork permits and HOA paving rules vary by town.

Compare materials

Asphalt
$3k – $7k
ConcreteSelected
$3k – $8k
Pavers
$5k – $16k
Gravel
$579 – $2k

Each material at its typical depth, same size, site, and state.

iBallpark estimate for planning, not a bid. Assumes a rectangular pad on a standard base; soft soils, drainage work, and curb-cut/apron rules are the usual extras. Get 3 local quotes before signing.

Site data & assumptions: U.S. EIA · OpenEI URDB · Google Solar · NREL PVWatts · DSIRE · IRS · ENERGY STAR · Ballpark Lab model assumptions — see all sources

Frequently asked questions

How much does a driveway cost in Alabama?
A typical 600 sq ft (20 × 30 ft) two-car concrete driveway in Alabama runs about $3k – $8k installed, with labor roughly 11% below the national average.
Is asphalt cheaper than concrete in Alabama?
Yes, up front: the same 600 sq ft driveway in asphalt runs about $3k – $7k versus $3k – $8k in concrete — though concrete typically lasts longer with less resealing.
Do I need a permit for a driveway in Alabama?
A new curb cut or apron in the public right-of-way needs Alabama/municipal approval, and flatwork permits and HOA paving rules vary by town.

Driveway costs in other states